Datalogger

DL02

The DL02 unit is a high performance datalogger, designed to operate in a wireless network. The datalogger communicates with one or more measurement nodes, equipped with appropriate sensors. Each device has a radio modem operating according to the ZigBee standard; the communication takes place via a star network (denominated DataZig) in which DL02 is its center. The sensor data are sent from the measurement nodes to the datalogger and recorded on its non-volatile memory. At any time the data can be collected from DL02 to a PC using a standard USB interface.

Depending on the type of measurement, the network can use different types of radio modems (RM01, RM01-P) which are interchangeable and differs only for RF power transmission. Each modem is individually powered by a rechargeable internal battery. The autonomy depends on the sampling frequency of the node and can allow up to several months of continuous operation. Recharging the battery takes place within a couple of hours by placing the radio modem in the docking provided by the datalogger (DOCK0).

Thanks to the wireless communication is possible to perform measurements of various physical quantities providing galvanic isolation and avoiding any issue concerning ground loops.

The sample time of the data transmitted by a measurement node can be selected in a range of 1...65365 s). Each node consists of a radio modem and a signal conditioning device (FE01 or FE02 family) which are connected physically to the measuring sensors. In addition to the wireless nodes, DL02 can support simultaneously devices communicating via RS485 serial thereby increasing the versatility of the system.

The data sent from each measurement node are received by DL02 and synchronized to its internal clock with a resolution of 0.1 s.

There are various FE0x models; everyone can manage one or more independent channels allowing for the measurement of physical quantities of different kinds.

The datalogger automatically recognizes the type and magnitude of measurement, and it does not require any manual operation. You can add up to 30 measurement nodes to the network.

The figure on the left shows an example of a mixed network (wireless/wired) managed by a DL02 datalogger with four measurement nodes.

The real time data coming to the datalogger or the previously stored data can be accessed remotely via a PC connected to the telephone network with an analogue modem or via a PC using a GSM modem.